R
Rik Jones
Guest
Hi everyone,
This is my first post on this forum, so forgive me if someone has asked this before.
If you create a multi-body part to it's completion and then 'make components' to make it into an assembly. If you forget to add something later to the part model, is there anyway of adding the new component without redoing the 'make components' assembly again?
Many thanks
Rik Jones
This is my first post on this forum, so forgive me if someone has asked this before.
If you create a multi-body part to it's completion and then 'make components' to make it into an assembly. If you forget to add something later to the part model, is there anyway of adding the new component without redoing the 'make components' assembly again?
Many thanks
Rik Jones
