I have heard about a process that produces micro voids that reduce warpage and eases the molding process with only 5% reduction in strength. It sounds like a foaming process, but the voids are very small. I have had parts made with the process, and you can detect a faint micro-pore pattern in the midsection. Any tips on contacts for this "Mu Cell" process?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mu Cell Process - Any Tips? 1
- Thread starter plasgears
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question