I'm running AutoCAD LT 2008 and editing a large Mtext block with columns. After clicking ok to save and get out of the text editor, I get a message that says "Mtext may be truncated. Save anyway?", with only 2 options: OK or Cancel. And sure enough, when I hit OK, the last part of the last column is gone. I've tried changing from static to dynamic columns and back again, and my grips for the block are well outside the text (not that that should matter), but to no avail. Any suggestions would be greatly appreciated.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
mtext truncated in AutoCAD LT 2008 1
- Thread starter maxeng1
- Start date
- Status
Similar threads
- Locked
- Question
