Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Moving part in assembly problem

Status
Not open for further replies.

Mxious

Mechanical
Joined
Dec 7, 2004
Messages
38
Hi I have an assembly with some part and some other sub-assembly. My problem is, when I want to move part or sub-assembly or put contraint, Is't take a lot of time to get mouved. This is happen when I load a part from a catalog.
Is this a computer problem or a software problem. If i turn the CACHE ON or OFF, this is have no change....

I run on CATIA V5 r13 sp 4

thank !!
 
I can move parts and sub-assemblies easily even for huge assemblies. I think your computer (specially your graphic card maybe) has a problem.

Regards,
Fabien
 
This is happen when I load a part from a catalog.
Is this the only time you experience this problem?
What happens when you load a part from somewhere other than the catalog?
 
YES IT'S HAPPEN ONLY WHEN I INSERT PART FROM CATALOGUE
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top