alanled
Mechanical
- Dec 7, 2003
- 42
Im a bit rusty at autocad 3d and was wondering if it is possible to move holes etc after they have been drawn to save you having to redraw
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
moving holes etc in autocad 2007 3d
- Thread starter alanled
- Start date
- Status
- Status
Similar threads
- Locked
- Question
