Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Move Command

Status
Not open for further replies.

jerry1423

Mechanical
Joined
Aug 19, 2005
Messages
3,428
Location
US
How do I oriente the handle to a hole edge? I am on NX7.5

When I set the motion to Dynamic and Move Handle Only
I have the option of moving the handle from CYSS to CYSS, but that doesn't do it . . . all I want to do is orient the handle it to an arc,
Why is that so dang hard ???

I can't tell you how much I dislike working with the Move command Move Component command.
Please bring back the old way of doing this.

 
Click the axis that you want to use as the normal direction then click the arc. When you roll over the axis it may highlight, but when you click on it nothing seems to change (needs better feedback, imho); even so, when you click the arc, the dynamic csys will orient to the plane of the arc. If you want/need to reverse the direction, double click the arrow head.



www.nxjournaling.com
 
When you click on the origin handle make sure the snap points are enabled.





John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6 & NX7.5
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top