I am having issues on one machine with 24v dc outputs going bad on a Micrologics 1000. I am controling solenoid coils and I expect the problem bay be coming from the coil closing.I do have 1.5A fuses and my outputs are rated at 2A I would like to put an MOV in line to protect my outputs. how do I calculate the correct MOV to use ?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mov calculation
- Thread starter Bullet370
- Start date
controlsdude
Electrical
since its 24vdc it would be an mov 24vdc. but since its a dc coil you can also use a diode across the coil.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question