Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Motion Analysis

Status
Not open for further replies.
Muon1

Muon1

Mechanical
Joined
Jan 21, 2013
Messages
17
Location
GB
Hi,

I'm currently using motion analysis to workout the required torque to rotate a part, but I've run into a problem. The motion analysis settings for the units of torque are N.m, how do I change this to mN.m?
Is there also a way to get the torque values without using a graph, just the actual values?

Regards

Muon.
 
Sort by date Sort by votes
I've had a look but I can't seem to find how to do it, sorry. It seems just to output Newton meters, not milliNewton Meters.

Hopefully someone will help.
 
Upvote 0 Downvote
Sorted it.

Didn't realize that N.m could be changed to mN.m in document properties - units.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

BiPolarMoment
  • Locked
  • Question Question
Volume Packing Analysis
Replies
4
Views
487
telecomguy
telecomguy
L
Solidworks Motion Study
Replies
0
Views
1K
Letcic
L
M
Motion study
Replies
0
Views
2K
MirkoZ
M
B
Motion Study Collaspe
Replies
1
Views
2K
Cadasio
C
M
Help with Motion study
Replies
0
Views
1K
MirkoZ
M

Part and Inventory Search

Sponsor

Back
Top