Controlling difficult systems
Controlling under damped systems
Does anybody look at these?
Peter Nachtwey
Delta Computer Systems
Controlling under damped systems
Does anybody look at these?
Peter Nachtwey
Delta Computer Systems
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
More Webinars
- Thread starter PNachtwey
- Start date
- Thread starter
- #3
There are more at
I stopped posting links because no one seemed interested.
Peter Nachtwey
Delta Computer Systems
I stopped posting links because no one seemed interested.
Peter Nachtwey
Delta Computer Systems
- Thread starter
- #4
This one is about advanced press control.
Beside meeting the precision requirements, minimizing cycle time is important too.
There are two main methods
1. Use a big and small valve approach. This is what is discussed in the video.
2. Use jack or kicker cylinders to move a big ram but using only one valve.
Both method allow for fast motion when closing as fine pressure control when closed.
Peter Nachtwey
Delta Computer Systems
Beside meeting the precision requirements, minimizing cycle time is important too.
There are two main methods
1. Use a big and small valve approach. This is what is discussed in the video.
2. Use jack or kicker cylinders to move a big ram but using only one valve.
Both method allow for fast motion when closing as fine pressure control when closed.
Peter Nachtwey
Delta Computer Systems
- Status