Hi, all. I have defined a mooney rivlin material in abaqus, with a predefined set of points to elongation at break. However, I experience the material to take up more stress than what the material is capable of, based on a uniaxial stress strain curve. The stress state is triaxial, although the analysis is 2d axixymmetric. How can this be, and what is the failure mode?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mooney Rivlin Hyperelastic material failure
- Thread starter blckwtr
- Start date
Similar threads
- Locked
- Question
