Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
MOM variables for peck drill
- Thread starter bisrana
- Start date
The best way to find any MOM variables is to turn on the review tool in the post. Output Settings - Other Options - Activate Review tool and then save the post.
When you post you will get the output reviewer and all of the variables that are active during each event.
DO NOT post a large program as this also takes a while to display. Create a short program to evaluate only the info you need. In your example post only the drilling operation that has the peck cycle and then look at the MOM variables.
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6.0.5.3
When you post you will get the output reviewer and all of the variables that are active during each event.
DO NOT post a large program as this also takes a while to display. Create a short program to evaluate only the info you need. In your example post only the drilling operation that has the peck cycle and then look at the MOM variables.
John Joyce
N.C. Programming Supervisor
Barnes Aerospace, Windsor CT
NX6.0.5.3
- Thread starter
- #4
- Status
