GrumpyPlasticBastard
Materials
- Jun 10, 2010
- 29
I mold an electrical insulator, six at a time. The machine is an injection mold machine designed for rubber thermoset molding.
Material is a gray EPDM compound, our mold is running at 375 degrees.
Tried many different release sprays... most just bake to the mold and cause issues. Some give release but only last one cycle. That's expensive.
I cannot change the machine mold material or process at this point... what other options are out there for release agents for this application.
Material is a gray EPDM compound, our mold is running at 375 degrees.
Tried many different release sprays... most just bake to the mold and cause issues. Some give release but only last one cycle. That's expensive.
I cannot change the machine mold material or process at this point... what other options are out there for release agents for this application.