MODIFYING EXISTING PATTERN TABLES?

[93Civic_hb]

I'M USING PRO/E 2001 ED.


I HAVE A QUESTION CONCERNING WITH MODIFYING EXISTING PATTERN TABLES. CURRENTLY THE FEATURE THAT ISPATTERNED CONSISTS OF A HOLE. IN MY PATTERN TABLE THERE ARE TWO COLUMNS THAT ARE MY X AND Y TO LOCATE MY NEXT FEATURE. IS THERE AWAY TO MODIFY THIS EXISTING PATTERN TABLE TO HAVE AN ADDITIONAL COLUMN THAT DISPLAYS THE HOLE DIAMETER? SOME FEATURES ARE DIFFERENT SIZES THAN OTHERS, AND I'M HAVING A HARD TIME PLACING THIS FEATURE ID # INTO THE COLUMN OF THE PATTERN TABLE.


I KNOW HOW TO MAKE THIS WORK BY RECREATING THE PATTERN TABLE AGAIN, BUT I WAS WONDERING IF IT IS POSSIBLE TO MODIFY IT.


THANKS FOR YOU INPUT...


JUSTIN

 

[Israr]

please place your question in the right forum. You should put in in modeling forum.


this is analysis forum.


Israr