Vidaman
Mechanical
- Jul 28, 2002
- 39
I have a chart where I would like to control the range of values to be plotted by changing the range value in a cell. That is, one time I may want to plot all 100 points of a series, next I might want only to plot 50 of them.
Right now I manually adjust the series range by going into the "Source Data.." controls. I would like to tie the range to a cell value instead.
If you can actually understand my question, your help will certainly be appreciated.
Thanks
-Vidaman
Right now I manually adjust the series range by going into the "Source Data.." controls. I would like to tie the range to a cell value instead.
If you can actually understand my question, your help will certainly be appreciated.
Thanks
-Vidaman