Modify Sketch Text via design table

[Russell67]

I have a series of rollers, same bore configurations just different o.d. geometry. I have created a generic blank (default) part and in that part i have a cut extrude of the roller number. This was created via sketch text. My generic part has "XX". From this part i have created my 16 different profiles and want to change that text for each roller (ie 1T, 1B, 2T....). Can i do this with a design table? Thanks

 

[CorBlimeyLimey]

Yes and No.

You will have to create the sketch text manually, but once created you will be able to control the suppression state with the DT.

 

[J-C]

And fillout an enhancement request on the Solidworks site.

Jason

SolidWorks 2007 SP4.0 on WinXP SP2