Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Modelling Adhesives
- Thread starter g1nunn
- Start date
it depends on the application.
if it's a composite, you enter it as a layer with the shear strength known for the adhesion of the materials, and thats basically it.
most loads the adhesive takes are shear, from uneven strain of the connected elements.
if it's a composite, you enter it as a layer with the shear strength known for the adhesion of the materials, and thats basically it.
most loads the adhesive takes are shear, from uneven strain of the connected elements.
- Status
Similar threads
- Locked
- Question
- Locked
- Question