I'm trying to model a pzt ring in ansys to do a modal/harmonic analysis. The first of possibly a few problems, is that I don't seem to be able to change the point mass. It defaults to the edge of the ring and it needs to be at its centre, so the modal analysis is waving at me like a beam. Any ideas what command to use? I'm using Mechanical APDL. Thanks. Antknee.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Modelling a pzt ring?
- Thread starter antknee
- Start date
- Thread starter
- #2
- Status