modeling of beam to wall interface in abaqus

[61686168]

hi all,
I modeled a steel coupling beam into concrete shear wall,
i am going to verify an exprimental model,but i steel couldn't get it, i think my problem is in modeling of beam to wall interface, i used embedded constraint, but it hasn't correct result,
please help me.
thank you

 

[rstupplebeen]

Depending on your goal you can merge together the solids or use a coupling constraint among others. You may get more responses in the Abaqus forum.

Rob Stupplebeen

https://sites.google.com/site/robertkstupplebeen/

 

[61686168]

thank you,
I was going to use coupling constraint between one point in beam and one point from wall,but when i used coupling constraint and run,the job aborted and was not converge,
i sent my inp file.
thank you

 

[rstupplebeen]

Unfortunately I have never used embed so hopefully someone else has experience with this. Depending on your goal you may want to model the I-beam as solids.

Rob Stupplebeen

https://sites.google.com/site/robertkstupplebeen/