Jan 27, 2022 #1 Abdullah J Structural Dec 6, 2017 4 How to model an opening in the web of a hot rolled steel W section using ETABS ?
Jan 27, 2022 1 #2 jayrod12 Structural Mar 8, 2011 6,267 It's likely easier to just model it without, and then run the numbers for the hole by hand. It's not overly complicated. Use the analysis results from ETABS to know the moment and shears at the location of the hole. Upvote 0 Downvote
It's likely easier to just model it without, and then run the numbers for the hole by hand. It's not overly complicated. Use the analysis results from ETABS to know the moment and shears at the location of the hole.
