missing parts in lightweight

[swforge]

Hi all,
When bouncing in and out of assemblies editing parts, I see these parts are missing when going back to the assembly. I believe it only happens in assembly lightweight mode and Solidworks may know about it already.
Has anyone else seen this in SW2009 sp3.0

 

[Gupta65]

Never seen this. Does it happen with each assy.

Deepak Gupta
SW2009 SP3.0
SW2007 SP5.0
MathCAD 14.0

 

[swforge]

Yes. SW apparently knows of the problem I've recently found out. Maybe it willl be addressed. Thanks