Mirror a Weldment Profile

[TateJ]

I'm using the WELDMENT feature to make a weatherstrip seal around a cabinet door. The sketch that drives the "sweep" is in context (in my assembly part). I made the custom profile feature & is works fine. but how do I get the profile sketch to MIRROR in my part? all I can do by locating it is to rotate it. This is making me crazier!

Windows XP / Wireless Intellimouse Explorer
SolidWorks 2007 SP1.0 / SpaceBall 5000
Lava Lamp
www.Tate3d.com​

 

[edsongebo]

Hey Draftsman101...as we folks here in Massachusetts say..."Wicked pissa!" How long did that take you to create?

Edson Gebo
Mechanical Designer/Drafter
SW2007 SP2.0
Cadra 2006 (yup 2D still exists)
-------------------------------------
Sometimes Success Begins at Failure
-------------------------------------

 

[draftsman101]

It only took about 2 weeks because I was haveing to work around the guy that was working on it. FYI: Its a work in progress.

For those of you that are wondering, it is a GeeBee Model "Y"