I'm using Polyethylene tubing as innerduct in a gas pipe. The internal pressure of innerduct is 0 psig. Would the minimum bend radius specified for innerduct assumed to be used to contain internal pressure still apply, or could a smaller bend radius be used without compromising integrity? Plastic pipe is often coiled with a bend radius less than that specified for permanent installation.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Minimum Bend Radius of Plastic Pipe
- Thread starter sloquick
- Start date
Similar threads
- Locked
- Locked
- Question
- Question