Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Microfluidics Chip 3D Printing

Status
Not open for further replies.

Helepolis

Mechanical
Dec 13, 2015
199
Hi,

If you create microfluidics chips using 3D tech, please share what printer was used and the smallest functional feature successfully printed.

We used the Form 2.
25mm tube, I.D 3mm. wall thickness 0.3mm.
Support fins, thickness of 0.3mm, width 5mm, bridging a 5mm gap.
Closed duct, I.D 1-1.2mm (elliptical), embedded in a side wall.

Thanks,
DS
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor