Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
metric machine tolerences
- Thread starter roadcapt
- Start date
Metric Standards for Worldwide Manufacturing:
Tolerance zones, R6 comes from a table for internal dimensions (mm) (Holes).
You need to look at the chart (ANSI B4.2)
and R6 is the column tha corresponds to a specific row of hole sizes.
There are 25 different sets of values (0-500mm)
You need the chart, or you need to give us the specific hole size.
Charlie
Tolerance zones, R6 comes from a table for internal dimensions (mm) (Holes).
You need to look at the chart (ANSI B4.2)
and R6 is the column tha corresponds to a specific row of hole sizes.
There are 25 different sets of values (0-500mm)
You need the chart, or you need to give us the specific hole size.
Charlie
Check this link:
That should give you the info.
Benta.
That should give you the info.
Benta.
Opps, Big R for holes, Little r for shafts...
Regardless, look up ANSI B4.2 or ISO 1829
Charlie
Regardless, look up ANSI B4.2 or ISO 1829
Charlie
- Status
Similar threads
- Question
- Locked
- Question
- Locked
- Question