Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

METAL INJECTION MOLDING

Status
Not open for further replies.
PedroArrochella

PedroArrochella

Mechanical
Joined
Sep 6, 2004
Messages
3
Location
PT
I do mainly plastic injection mold but at this moment I´m doing a four cavity mold for Al injection and finding very dificult to obtain a calculation procedure for the runner and gate, can anyone advise some literature for MIM?

Best regards
Pedro Lobo
 
Status
Not open for further replies.

Similar threads

fortjp500
  • Locked
  • Question Question
Square captured nuts in sheet metal
Replies
5
Views
2K
fortjp500
fortjp500
Peter Glus
  • Locked
  • Question Question
Needhelp securing nuts to a metal plate
Replies
16
Views
4K
SnTMan
SnTMan
Sicilian Engineer
  • Locked
  • Question Question
Mechanical Design of Injection Moulded Products for 'Consumer Electronics'
Replies
8
Views
937
ShataCastings
ShataCastings
guyst
  • Locked
  • Question Question
Straightness of a bend on sheet metal parts
Replies
13
Views
4K
ShataCastings
ShataCastings
innominata
  • Locked
  • Question Question
Incorporating a LED indicator into a Plastic Enclosure with Injection Molding
Replies
6
Views
1K
innominata
innominata

Part and Inventory Search

Sponsor

Back
Top