Helrezer
Mechanical
- Nov 20, 2012
- 21
In April, David asked about mesh quality in Ideas.
I do not know any relationshiip between what Patran has and what Ideas has.
Ideas recommended 0.3 or above for stretch and distortion. These values were based on the normalization of the Jacobian. They were for the Model Solution elements, but worked well with most solvers.
This information is in the training materials for Ideas.
Marilyn Tomlin
Siemens PLM Software
I do not know any relationshiip between what Patran has and what Ideas has.
Ideas recommended 0.3 or above for stretch and distortion. These values were based on the normalization of the Jacobian. They were for the Model Solution elements, but worked well with most solvers.
This information is in the training materials for Ideas.
Marilyn Tomlin
Siemens PLM Software