DSchmidt04
Mechanical
When having a completed FEA model in either section clipping or section view is there any way to show the mesh on the actual cross section portion. Below is a picture of where I need the mesh to be shown at.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Mesh Cross Sectional View
- Thread starter DSchmidt04
- Start date
- Status
- Status
Similar threads
- Locked
- Question
- Locked
- Question