Please, about assistance about si cam because when i made a program si cam technologi ok, malingering does not have clash, generate under processor ok but when i send the program to the machine appear EIA/ISO error and does not have all details in graphics and some lines of unknown origins are imposed. Can it be what?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
mazak hypergear 510
- Thread starter Poczwi
- Start date
Hi, never used si cam but one thing that can give you an eia/iso error is that paramters #101 and #102 need to be set to 1.0000. These are part counts from a previous program and if they have not been set back to 1.0000 and you then try to load in a new program you will get the eia/iso error.
- Status
Similar threads
- Locked
- Question