mazak hypergear 510

[Poczwi]

Please, about assistance about si cam because when i made a program si cam technologi ok, malingering does not have clash, generate under processor ok but when i send the program to the machine appear EIA/ISO error and does not have all details in graphics and some lines of unknown origins are imposed. Can it be what?

 

[xbiggy]

Hi, never used si cam but one thing that can give you an eia/iso error is that paramters #101 and #102 need to be set to 1.0000. These are part counts from a previous program and if they have not been set back to 1.0000 and you then try to load in a new program you will get the eia/iso error.