I have a WPS that has been qualified to section IX. The PQR specimen was welded in the 1G position and P1 material was used. All requirements of QW-452, QW-160, & QW-194 were met. Due to a conflict of interests I need to pose the question "What is the max fillet weld size allowed per this WPS in the qualified position?"
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Max fillet weld size ASME section IX
- Thread starter CandCQC
- Start date
You say QW-452(?), this is for Performance qualifications, not a WPS/ PQR per QW-450? Please review the WPS and ensure that the WPS met the requirements of QW-450, QW-150, QW-160, & QW-194. If you are speaking of the Welder Qualification, if it was on a groove weld, the Welder is qualified for all thickness and diameters of Fillet welds.
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Question