Mathcad 13 in WF3 M030

[trillicomm]

I just installed a trial version of mathcad 13 to WF3 M030. I want to test drive the bidirectional link between those softwares.

I create an measurement feature analysis in ProE. I create a mathcad with some variables. Then select Mathcad Analysis in Proe, try to "marry" the platforms or some sort. ProE said that it sees no "tagged parameters for mathcad".

I can't seem to jumpstart this new integration.

Does anyone have any basic knowledge?

I know this integration is new to most of us. Feel free to recommdend anything.

Thank you for reading this post.

Maybe the admin can open a dedicated forum for Mathcad.

t.

 

[looslib]

There is a required patch to allow MathCad integration with WF3 M030. M040 has the patch built in.

 

[ecosgriff]

I have a similar question. I would also like to try to get the two programs to run together, but don't know where to start. I'm using Pro/E educational, although I'm not sureif it is M030/040... If I go to Help>About ProE, it gives me a date code F000.


Where would I find out whether or not I need to install the patch, and if I do need it, is it available on PTC's website?


Thanks for any help you might have!!


-ecosgriff

 

[looslib]

The patch will only work with M030 and can be downloaded from www.ptc.com.


The student edition/trial versions are only released at F00, initial buggy releases, and as far as I know, never released at newer build codes. Educational versions used by schools should be able to get newer builds. Getting the newer builds installed, especially during the school year, may be a challenge unto itself.