I am relatively new at using ACAD and mechanical desktop. I would like to determine the center of mass of a 3d assembly. I found the amassmprop function but the materials I am using are not listed. Is there a way to assign the physical properties of the materials to the different parts of the assembly?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
material properties
- Thread starter megok
- Start date
- Status
Similar threads
- Locked
- Question
- somdevyuvaraj
- Autodesk: AutoCAD
- KotaNagababu
- Autodesk: AutoCAD
- ktunph
- Autodesk: AutoCAD