Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Material info needed

Status
Not open for further replies.

mrfmachine

Mechanical
Joined
May 14, 2008
Messages
2
Location
US
I am in need of info on EN 10297-E470 material and a cross over to a US spec. Any help is greatly appreciated. Thanks Mike
 
Mike,

EN 10297 is a specification for seamless tubes. ASTM A 519 is the US equivalent. Grade E470 is a high Mn steel with a specified V content, and relatively high strength (yield = 470 MPa min, UTS = 650 MPa min, El = 17% min). There is no exact equivalent in A 519, but grade 1518 is close. I suggest you specify 15V18 according to ASTM A 519 with the following additional details:

V = 0.08-0.15
Nb = 0.07 max
Al = 0.01 min
Yield = 470 MPa min
UTS = 650 MPa min
El = 17% min

EN 10297-1 requires E470 to be delivered in the +AR condition, which is essentially normalized without any subsequent cold working or other heat treatment.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top