Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mate a Component to a Construction Sketch API VB

  • Thread starter Thread starter Finndus
  • Start date Start date
F

Finndus

Guest
I've recorded a Macro to create a part, then create an assembly with two construction sketches. I have gotten so far but cannot figure out how to instruct SolidWorks to correctly mate the component to the sketch.

https://forum.solidworks.com/message/251094#251094
Above shows where the macro finishes

Below shows what I'm trying to achieve
https://forum.solidworks.com/message/251094#251094

Any ideas on how to mate this component?

Please find attached the .swp file
https://forum.solidworks.com/message/251094#251094
 

Part and Inventory Search

Sponsor

Back
Top