Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mass Properties for an assembly

Status
Not open for further replies.
mjb60

mjb60

Petroleum
Joined
May 19, 2003
Messages
9
Location
US
I'm a new user of Pro-E 2000i2. Every time I open my assembly it goes through and calculates the mass properties of every part in the assembly. This takes awhile for the assembly to come up. Is there a toggle I can use to switch this function off?

Thanks,
Matt
 
Sort by date Sort by votes
Change the config.pro option "mass_property_calculate" from "Automatic" to "by_request"
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

whatev-nvm
  • Locked
  • Question Question
OBJ of a simp rep of an assembly gets exported with incorrect coordinate system
Replies
0
Views
1K
whatev-nvm
whatev-nvm
J
  • Locked
  • Question Question
How to disable auto snapping in assembly?
Replies
1
Views
2K
3DDave
3DDave
shanemolloy
  • Locked
  • Question Question
Replacing a component in an assembly based on excel
Replies
0
Views
377
shanemolloy
shanemolloy
oharag11
  • Locked
  • Question Question
Reassign 0-0 for Ordinate Sims - CREO 10
Replies
8
Views
2K
3DDave
3DDave
DesEngineer4
  • Locked
  • Question Question
THREAD Check in Assembly
Replies
2
Views
598
3DDave
3DDave

Part and Inventory Search

Sponsor

Back
Top