Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Marking a reinforcement pad in PVelite 2017 as impact tested

Thread starter VesselFred
Start date Dec 20, 2017

Status: Not open for further replies.

Dec 20, 2017

VesselFred

Mechanical

Dear All,

Where can I indicate in PV Elite 2017 that the reinforcement pad I use for reinforcement of a nozzle has been impact tested (pad material is SA516-70) ?

If I don't do this I will get a warning that the Computed overall MDMT was higher than the required value !

Appreciate your answer or tip how to do this.

Best regards

VesselFred