R
riazamir
Guest
kindly give me some manufacturing tips
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
- Status
- Thread starter
- #2
C
ctarmijo
Guest
Dear riazamir,
It is hard to give you any manufacturing tips when you do not indicate what you are working towards in detail. Are you doing turning, milling, post processor creation, wire edm, sheetmetal, fixture design, or tooling? There are too many areas which manufacturing encompasses. If you can be more descriptive that will help greatly.
CTArmijo
It is hard to give you any manufacturing tips when you do not indicate what you are working towards in detail. Are you doing turning, milling, post processor creation, wire edm, sheetmetal, fixture design, or tooling? There are too many areas which manufacturing encompasses. If you can be more descriptive that will help greatly.
CTArmijo
- Thread starter
- #3
A
adicar01
Guest
- Thread starter
- #4
L
le1034
Guest
You may contact Mike Nye at http://www.proactiveservices.com or Larry at lelie@norse.com These guys are wizes at the manufacturing. They can really simplify the process to a fool-proof level. Contact Mike at 913-642-5038 Fax 913-642-8415
- Status