Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Manifold Design

Status
Not open for further replies.

1503-44

Petroleum
Joined
Jul 15, 2019
Messages
6,705
Location
ES
I thought I'd play with some manifold configurations. The best way to arrange 3 meters between headers, etc. The question comes up a lot here, so... avoid the both entry and exit at meter 1, the other two, entry at meter 1, exit at meter 3, or entry at meter 2, exit at meter 2, are acceptable with scarcely any differences at all.
And keep your header diameters at least 1.33 x branch run diameters.

MANIFOLD_CONFIG_buouil.png


Statements above are the result of works performed solely by my AI providers.
I take no responsibility for any damages or injuries of any kind that may result.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top