Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Mandatory Length for Conical Section?

Status
Not open for further replies.

takiyasamsama

Chemical
Joined
Feb 10, 2015
Messages
108
Location
MY
Hi,

Is there any mandatory length for designing a conical secion? For example the total height of the vessel is 1450mm, what would be the recommended or mandatory height for the conical length/height?

Thank you.
 
Height of cone is depends on the cone apex angle. Apex angle is 60 degrees in most cases.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top