ashwani1973
Mechanical
i have a problem. when i make hole, expression tool bar not activated in hole sketch environment. pls help.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
making hole using expression in nx6
- Thread starter ashwani1973
- Start date
- Status
TaylorAnderson
Mechanical
Sorry... Struggling to understand the question. Might you be able to post a picture of the "expression tool bar" you're expecting?
Taylor Anderson
NX Product Manager, Knowledge Reuse and NX Design
Product Engineering Software
Siemens Product Lifecycle Management Software Inc.
(Phoenix, Arizona)
Taylor Anderson
NX Product Manager, Knowledge Reuse and NX Design
Product Engineering Software
Siemens Product Lifecycle Management Software Inc.
(Phoenix, Arizona)
- Thread starter
- #3
ashwani1973
Mechanical
attaching screen shot for your reference, hope to understand the question
well that is kind of interesting, 
If one ( in modeling) activates the sketcher task environment, the expression editor is available.
But if i initiate the hole feature, select a face , the sketcher task environment again activates, but now the expression editor is not available.
Taylor ?
Regards,
Tomas
If one ( in modeling) activates the sketcher task environment, the expression editor is available.
But if i initiate the hole feature, select a face , the sketcher task environment again activates, but now the expression editor is not available.
Taylor ?
Regards,
Tomas
- Status