V
vklvsy
Guest
How do you get gears spinning when u make them? is there a process?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
- Thread starter
- #2
T
ttraser
Guest
use simulation. read help files.
good luck.
good luck.
- Thread starter
- #3
V
vklvsy
Guest
thank you!
- Thread starter
- #4
G
gupta9665
Guest
Check this: http://gupta9665.wordpress.com/2009/06/11/how-
to-animate-simple-spur-gear-in-solidworks/
to-animate-simple-spur-gear-in-solidworks/
