Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Making elements transparent in viewer

Status
Not open for further replies.
You can use Create Display Group within Visualization module.
Example:
Item: Elements
Selection method: Pick from viewport (an then select the elements you want to hide)
Perform a Boolean on viewport...: Remove

Also you can save your display group for later use.
 
Actually I want the software to automatically make elements transparent. For example, I want to see all stresses in a certain range. Elements that are outside this range should become 'invisible'. Is that possible?

Online Engineering Spreadsheet Caclulators
 
Yes,
the procedure is the same, but for "Selection method" select "Result value" and the upper and lower values of the displayed stress field.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top