vijay sawade
Mechanical
I want to make 1.2 mm thickness of sheet metal part and this will (same thickness) required to come when every time i open NX9...
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Making default Sheet Metal Thickness in NX
- Thread starter vijay sawade
- Start date
- Status
ranjithbelur
Automotive
Go to customer defaults, there select sheet metal----->general----->global parameters----->material thickness
there you can enter the value you need(in your case it is 1.2)
apply the changes, then close and reopen the NX
there you can enter the value you need(in your case it is 1.2)
apply the changes, then close and reopen the NX
- Status
