hello - I have a pic & place device that I have configurations in the model for up/down & in/out - if & can I make an animation out of this using the already created configurations to make this move - I am using solidworks 2016 - any info or help would be greatly appreciated - thank you
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
making animation from configurations
- Thread starter duk748
- Start date
Since your using SW 2016 look into the "mate controller" they added this year. I have been able to make some nice videos very fast with it. I am not sure how it interacts with configurations, but you can likely copy the numbers from your configurations into the mates and do it quickly.
- Status
Similar threads
- Locked
- Question
- Locked
- Question