Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
make rigid body
- Thread starter C.Amini
- Start date
- Thread starter
- #3
hello L_k
thank you.
I am using ansys apdl...and the tree you mentioned i dont know where it is.
i am doing subsequent analysis and i have to model it in ansys/multiphysics apdl. but one of objects is not important in my analysis
primary analysis was done in the ansys/multiphysics apdl .thats why for continuing analysis i want to model in the same enviroment
thank you.
I am using ansys apdl...and the tree you mentioned i dont know where it is.
i am doing subsequent analysis and i have to model it in ansys/multiphysics apdl. but one of objects is not important in my analysis
primary analysis was done in the ansys/multiphysics apdl .thats why for continuing analysis i want to model in the same enviroment
- Thread starter
- #4
rickfischer51
Mechanical
Give the punch an elastic modulus 3 or 4 orders of magnitude larger than the material you are punching.
Rick Fischer
Principal Engineer
Argonne National Laboratory
Rick Fischer
Principal Engineer
Argonne National Laboratory
- Status
Similar threads
- Question
- Locked
- Question