macro for multiple drawing rev table release

[swmetal]

Hi all
I need to add the same information in rev tables on lots of drawings. Has anyone seen a macro to help, or do I need to add one at a time? Thanks

 

[fcsuper]

I have a macro that will allow you to quickly enter in info on a Rev Block. It could be easily edited to enter in the same info each time it is run. However, if you are looking for something that will open all of your drawings and make the change for you automatically, that will take a bit of work.

http://sw.fcsuper.com/index.php?name=UpDownload&req=viewdownloaddetails&lid=16

Matt
CAD Engineer/ECN Analyst
Silicon Valley, CA

http://sw.fcsuper.com/index.php

 

[swmetal]

Thanks fcsuper for the file.