Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
machining weartec ASSAB
- Thread starter xoxokid
- Start date
I was reviewing the machining data from the below website. This material is tough to machine. Lower the cutting speed and increase your feed. This material probably work hardens also. Make sure the material is fully annealed.
- Status
Similar threads
- Locked
- Question
