Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Machining a conical screw!!!

Status
Not open for further replies.
vivaldi

vivaldi

Mechanical
Joined
Feb 19, 2002
Messages
6
Location
SE

How can I machine a titanium conical screw which has a taper angle 22 degree and a pitch 0.8mm (Number of revolutions=4)?

Regards,
 
Sort by date Sort by votes
A lathe with a taper attatchment should do the trick.
 
Upvote 0 Downvote
you didn't say if the 22 deg angle was included or single side. if single side, I doubt a taper attachment will accomodate you very well. this is easiest to do on cnc.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

dogbural
  • Locked
  • Question Question
machining a long tube (380mm)
Replies
8
Views
4K
Gr8blu
Gr8blu
MF Afif
  • Locked
  • Question Question
Element deletion on the broken chips during machining
Replies
1
Views
1K
Stick.
Stick.
CTengIS
  • Locked
  • Question Question
Machining marks and surface texture
Replies
1
Views
605
CWB1
CWB1
yoshiKoshi
  • Locked
  • Question Question
Calculating linear/thrust force from a linear ball screw and motor combinaton
Replies
2
Views
2K
yoshiKoshi
yoshiKoshi
quizzical1
  • Locked
  • Question Question
316SS machining vendors....
Replies
1
Views
366
bcd
bcd

Part and Inventory Search

Sponsor

Back
Top