Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Machine surface finish for sheetmetal

Status
Not open for further replies.

ashivu123

Aerospace
Joined
Oct 24, 2013
Messages
153
Location
US
I have sheet metal assembly drawing contains Piece part and assembly details. In four places Self-Clinching Fasteners is getting assembled. After assembly the head of the screw is slightly protruding outside the surface. Does it violate surface finish? As it contains Machine surface finish 125 in the drawing block. Sheet thickness is .1 inch.
 
In my opinion it does not, because the surface finish applies to only machined surfaces.

There are other forums within eng-tips that you should get a better response.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top