Reading up on electrical machine design it seems most if not all designers used permeance in their calculations. Is there any reason why they don’t use reluctance? I’m assuming there are pros and cons for both, theoretically, mathematically, etc. Anyone here care to divulge on both sides of the argument???
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Machine design: Permeance vs Reluctance ??
- Thread starter jpcqub
- Start date
- Status
Similar threads
- Question
- Question
- Question